3D Print – SaIG.zone

Raspberry & Octoprint

Posted by stefansiglon July 19, 2018July 19, 2018in 3D Print, UncategorizedLeave a comment

To print stuff on your 3D printer you either handle those nasty sd-cards or you have a pc attached to your printer running all the time. To "FIX" this i decided to set up a raspberry pi with octoprint…

Strain relief for the heatbed cables Pursa i3 / Thingiverse

Posted by stefansiglon June 2, 2018June 1, 2018in 3D Print, UncategorizedLeave a comment

I red a lot about the cables that power the heat/build plate to loosen or suffering from material fatigue and I didn't find a thing that was fitting my printer setup so I designed one myself and decided to share…

Warping – Bed leveling and the settings

Posted by stefansiglon May 4, 2018May 1, 2018in 3D PrintLeave a comment

Try Try Try and Try again until you get it right ... well thats what i did and still trying to do it better ... https://youtu.be/W7yP7n0fPJo Leveling the bed was not so much of a problem for the first print,…

CURA and the first print

Posted by stefansiglon May 2, 2018April 30, 2018in 3D PrintLeave a comment

Cura is the slicer software of my choice. Why? Well i didn't knew much when i started using it ... and it was recommended by the handbook of the 3D printer. So I set up Cura it was really simple…

3D Printer – Pursa i3

Posted by stefansiglon April 30, 2018April 30, 2018in 3D PrintLeave a comment

3D Printer are in our lives for such a long time now but i actually didn't get in touch with one myself so ... I bought the Anycubic Pursa i3 when it was on sale 🙂 I actually already printed…